precautions for the use of plastic buckets

- Dec 23, 2019-

1. The outer cover needs to be tightened with external force (the torque wrench can be used to tighten the wrench). After the seal ring is assembled, it must be in close contact with the contact surface of the barrel mouth. It is forbidden to distort the seal ring.

2. If the temperature of the filling product is higher than 40 ° C, the filling and tightening of the cover and stacking must be cooled at the product temperature to normal temperature; when stacking, pay attention to the flat stacking, the maximum contact area of the upper and lower layers of the stacking, Positive, it is forbidden to stack piles in this way; this can avoid plastic barrel deformation.

3. If the filling products are prone to generate volatile gases, especially in February, April and August when the temperature difference effect is obvious, the lowest temperature of the day should be selected for filling, so as to avoid the concave deformation phenomenon.

4. Compatible dangerous goods and plastic barrels of our company shall not undergo compatible chemical reactions.

5. The weight or specific gravity of the dangerous goods contained in the plastic barrel must not exceed the maximum weight or specific gravity of the content it can carry.

6. Plastic barrels with low hazard category shall not be used to pack dangerous goods that require high category packaging.

7. Do not use plastic barrels without vent holes to transport dangerous goods that will release gas during storage and transportation.

8. The weight or volume of the dangerous goods contained in the plastic barrel must not exceed the highest limit of the international rules for the transportation of dangerous goods.

9. After filling the dangerous goods, it must be ensured that the seal of the package is firm (the inner seal of the plastic bag of the plastic bucket must be well sealed or the mouth is firmly secured), and there is no leakage or leakage.

10. When plastic barrels are loaded with dangerous goods, they must not corrode or damage the outer surface of the plastic barrels, and their appearance is clean.https://www.fhpails.com/