How to make a logo in an open bucket

- Feb 22, 2020-

1. All open bucket signs are printed in one place (on the side of the open bucket body that is close to the weld), and the relevant signs can be found without turning the open bucket.

2. The open bucket logo is automatically punched on the barrel just before the barrel body is welded, so it is not necessary to compare the pre-molded barrel cover with the barrel body. Open buckets are not "dedicated" until welded, so there is very little chance of errors.

3. The marking can be changed easily and quickly by the welder operator, unlike the stamping shop where a complete set of molds is needed to change the stamping mark.

4. The logo stamp is a "ready made" part, so any future logos can be added at low cost.

5. The inner surface of the barrel remains flat after stamping. Therefore, there is no rupture or chipping of the liner as if it were molded on the lid.

6. Due to the use of molded barrel lids, the number of molded parts has been significantly reduced. Now that the inventory of barrel lids has been reduced, the sluggish, backward molding lid inventory method in the past will be cancelled.

7. Be flexible. The logo plate can be changed in about 20 seconds, so there is no need to arrange a production plan in advance for the stamping workshop in order to obtain accurate molding on the lid.https://www.fhpails.com/